Instructions for Installing Coinco’s Retrofit Logic Adapter (RLA) for new $20.00 Bill Acceptance Using Kit Number 408077

Authorized
Distributors

	Vending
	Amusement
	Car Care

Currency Upgrades:
$5 Bill
$5 Bill Upgrade

$10 Bill

Service Materials

FAQ's

Selection Guide

Instructions for Installing Coinco’s
Retrofit Logic Adapter (RLA) for new
$20.00 Bill Acceptance
Using Kit Number 408077

For use in: BA30B’s with 407602, 407982 logic boards
BA30SA/BA32SA’s with 407449 logic boards
(Chip Extractor, CA#923987 and Tuning Script, CA#921623 Not Included)

Kit Contents
Coinco Part Number Description Quantity
408060 RLA Assembly 1
923972 RLA Retaining Boot 1
923990 Kit Instructions 1

Installation Instructions

Note: ESD Sensitive, use proper precautions before handling the logic board.

Read instructions completely through before beginning.

1. Remove power to the bill acceptor.

2. Unplug the machine harness from the bill acceptor logic board.

3. Remove the strain relief retaining screw and slide the logic board out of the logic board cover.

4. Using chip extractor (CA#923987), gently remove the square microprocessor chip from its socket by placing the straight end of the extractor under one corner of the chip and prying up. Next, pry the opposite corner up in the same fashion.

5. With the old chip removed, gently press the RLA assembly into the logic board socket.

Note: One side of the brown RLA socket has its corner rounded off, this matches up with rounded corner on the logic board socket. Failure to plug RLA in correctly will result in permanent damage to the RLA assembly.

6. Once the RLA assembly is pressed in place, snap the RLA retaining boot over the RLA assembly.

7. Slide the logic board into the logic board cover and install the strain relief and screw removed in step 3.

8. Apply power to the bill acceptor.

Note: For BA30SA and BA32SA units, do NOT connect any harnessing to the 18 connector on the 407449 board at this time!

9. Insert one sheet of Coinco tuning script (CA#921623) into the dollar bill acceptor. The tuning script will be pulled in (like a dollar bill), then rejected.

Note: You only get one chance to calibrate the unit when power is first applied. If something goes wrong, the bill acceptor will have to be calibrated at your nearest Coinco branch office.
10. Turn power off.

Reconnect any remaining harnesses.

Kit Number 408077

For Technical Support please contact
techsupport@coinco.com.